Welcome, Guest
Username: Password: Secret Key Remember me
  • Page:
  • 1
  • 2

TOPIC: Rigol I2C Sampling - Signal/Channel Bleed

Rigol I2C Sampling - Signal/Channel Bleed 1 year 1 month ago #18020

  • NealXu
  • NealXu's Avatar
  • Offline
  • Fresh Boarder
  • Posts: 1
  • Thanks received: 1
Hi..i am anew user here. As per my knowledge the trace routing on the board affects the signal integrity of the edges, and the worse the integrity the more the crosstalk you get. 2 layer board or multi layer? 2 layers are much worse. If multi-layer, are the signals routed over a continuous plane?

pcba assembly
Last Edit: 11 months 4 weeks ago by NealXu.
The following user(s) said Thank You: hop

Rigol I2C Sampling - Signal/Channel Bleed 1 year 1 month ago #18021

  • hop
  • hop's Avatar
  • Offline
  • Platinum Boarder
  • Posts: 495
  • Thanks received: 46
I solved it mostly. I was prototyping and was using jumper wires for connections, AND a solderless bread board. I applied some decoupling caps, and went more direct with my probes. I still see the issue but it is very faint, almost non-existent. Thank you for the advice though. I have seen in other forums what you are talking about and it is something to consider.
  • Page:
  • 1
  • 2
Time to create page: 0.234 seconds